[Elecraft] Record both RX signal and TX monitor in CW

[Ken K6MR]

Config -> LIN OUT -> tap REV/2 button.  Use VFO A knob to adjust t= xxx to set transmit monitor level.  0 = none and up from there.  Mine are set at 010.  YMMV.

Ken K6MR

From: HP<mailto:pfizenmayer at q.com>
Sent: Wednesday, April 28, 2021 23:36
To: elecraft at mailman.qth.net<mailto:elecraft at mailman.qth.net>
Subject: [Elecraft] Record both RX signal and TX monitor in CW

Using AUDACITY and the K3S USB Audio Codec -recording received signals works fine-but is there a way to also record the TX monitor signal ?

Obviously I can run another computer running Audacity and simply record the speaker or headphone output
bit is there any way to avoid that ?

Hank K7HP

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k6mr at outlook.com