[Elecraft] K3/KPA500 question

[Bob McGraw]

Check to see that the AUX cable is properly seated at the amp and at the 
the K3.   If you have the KAT500, check the control cable is connected 
as shown on page 5, Figure 1 in the KAT500 manual.

Always secure the plugs with the supplied connector screws.  Just 
plugging in the connector is and invitation for issues.

73

Bob, K4TAX


Message: 6
Date: Fri, 23 Apr 2021 21:17:02 -0400
From: "Joe K2UF"<joe at k2uf.com>
To:<elecraft at mailman.qth.net>
Subject: [Elecraft] K3/KPA500 question
Message-ID:<mailman.8391.1619267475.3572.elecraft at mailman.qth.net>
Content-Type: text/plain;	charset="us-ascii"

I have my K3-KAT500-KPA500 working great.  The amp is off to the left side
and I can't see the display easily.  while working on building an auto
antenna switch  I noticed  that the band display on the amp does not synch
with the K3.  It seems to be random.  If I hit  one dit on the key  the amp
will synch the band with the K3.  I am not sure if this has been working
like this right along and just did not  notice.
  
Any ideas guys.
  
73 Joe K2UF