[Elecraft] Elecraft Digest, Vol 204, Issue 6

[Ray]

Ace Hardware has some screws in Black.
WA6VAB   Ray K3 #3824 



From: Don Wilhelm
Sent: Tuesday, April 13, 2021 2:49 PM
To: Tommy Judson; elecraft at mailman.qth.net
Subject: Re: [Elecraft] Elecraft Digest, Vol 204, Issue 6

Tommy,

I highly recommend that you get the proper screws from Elecraft to be 
certain they are the correct length.
Hardware store screw are normally not available in black, so why mess up 
the appearance of your KX2 with zinc plated screws.

73,
Don W3FPR

On 4/13/2021 11:36 AM, Tommy Judson via Elecraft wrote:
> Make a bad purchase good?
> Bought a KX-2 off the internet and have found that it is missing several of the screws that held the end plates on.  Asked about that and the seller said he tried to put some sort of protective end plates onto the radio but couldn’t do it so threw them away and put the original end plates back on.  What concerns me about just going to the hardware store and getting more screws (that might not be the proper thread/length) is I think two of the screws held the final output transistors onto that end plate which I assume was for that end plate to act as a heatsink.
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to wa6vab at gmail.com