[Elecraft] P3 Failure, and question

[Dave Cole]

Hi Dave New,

It does help, and thank you... Mine has come back to life as well, 
(power cycling it), and I am worried about turning it off now as well...

I will get an RSA from Elecraft and send it in...  I'll report back to 
the list what they find, and how long it took to get repaired.

If you discover the issue, please let me know if you would!  I won't be 
sending mine back tomorrow, but sooner than later.  Also, THANK YOU 
again for the information.

73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist, RFI
ARRL Asst. Director, NW Division, Technical Resources

On 4/12/21 6:39 AM, Dave New wrote:
>   I've been experiencing intermittent failures of the internal display, 
> as well as loss of at least one setting (Track/Fix).
> 
> I've been leaving the K3s/P3 powered on continuously, but recently 
> started turning them off, to save some 'always on' energy while trying 
> to figure out why our house is running about 1200 watts continuously.
> 
> So, when powering on the combination (the P3 is set to power on with the 
> K3s power), very nearly always now, the internal display fails to come 
> on, but the SVGA display always works.  Normally, cycling the power 
> switch on the P3 recovers the internal display, but just yesterday, I 
> had to cycle the power several times before it came up.
> 
> I'm now leaving things powered on, until I can troubleshoot what the 
> issue is.  I did go as far as looking in the P3 manual to see if there 
> is a coin cell battery in it, that might need replacing, but that is 
> apparently not so.
> 
> I'm concerned about the loss of settings, which may point to a corrupted 
> EEPROM.  Reflashing the P3 hasn't fixed this, and so far, I've not tried 
> a 'factory reset' on the P3, which would lose all my settings.
> 
> Hope that helps,
> 
> -- Dave, N8SBE
> 
> Quoting Dave Cole <dave at nk7z.net>:
> 
>> Rick,
>> A further thought on this...  Next time your P3 fails, can you try and 
>> grab an image from it using the utility?  I just thought of that, mine 
>> will not grab an image, when it is failed, so it is probably not the 
>> backlight on mine.
>>
>> 73, and thanks,
>> Dave (NK7Z)
>> https://www.nk7z.net
>> ARRL Volunteer Examiner
>> ARRL Technical Specialist, RFI
>> ARRL Asst. Director, NW Division, Technical Resources
>>
>> On 4/12/21 6:03 AM, Dave Cole wrote:
>>> Rick,
>>>
>>> Thank you!  I appreciate the datapoint in this.  I was just looking 
>>> over the schematic and came to the same conclusion...  It looks like 
>>> a backlight problem to me as well...  I tried to find a datasheet on 
>>> teh 4538 IC that appears to control it, but alas, nope.  I got mine 
>>> to come back on by power cycling it as well...
>>>
>>> Hopefully someone has actually fixed this, and knows which cap...
>>>
>>> 73, and thanks,
>>> Dave (NK7Z)
>>> https://www.nk7z.net
>>> ARRL Volunteer Examiner
>>> ARRL Technical Specialist, RFI
>>> ARRL Asst. Director, NW Division, Technical Resources
>>>
>>> On 4/12/21 5:27 AM, Rick Stanback wrote:
>>>> My P3 does the same thing.  If i keep cycling power it eventually comes
>>>> on and works.  I suspect there is a bad capacitor in the LCD backlight
>>>> power.  I have not actually looking into it yet.
>>>
>>> ______________________________________________________________
>>> Elecraft mailing list
>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>>> Help: http://mailman.qth.net/mmfaq.htm
>>> Post: mailto:Elecraft at mailman.qth.net
>>>
>>> This list hosted by: http://www.qsl.net
>>> Please help support this email list: http://www.qsl.net/donate.html
>>> Message delivered to dave at nk7z.net
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: 
>> http://www.qsl.net/donate.htmlMessage delivered to n8sbe at arrl.net
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net