[Elecraft] K2 LCD and Backlight assembly problems

[Bruce Forsberg]

I resoldered the LED backlight devices by applying a small amount of
pressure and resoldering each pin to make sure they were flush. This made
the pins of the LCD flush with the PCB holes. I soldered it this way and it
has worked. The LCD is working fine for my K2.

Bruce, WB6IZG

On Sat, Apr 10, 2021 at 6:05 AM Phil Le-Brun <pnlebrun at gmail.com> wrote:

> Bruce, I am having the same issue. The LEDs are flush to the board, the
> plastic overlay installed but then the LCD sits to high to get the pins
> through
>
> Phil, G0HHN
>
>
>
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to bruce.forsberg at gmail.com
>