[Elecraft] KAT500 Remote software help

[Gordon LaPoint]

Lyn,
     I have those docs, thanks.  I'm looking for the command line 
switches for the remote host software.  I have the serial port/serial 
speed, tcp port and time out.  I would like to know if there is any way 
to control the mode when the software starts, I know how to change it 
after its running, but I don't want to have to switch from "auto" back 
to "man" everytime the remote cpu boots.
Thanks,
Gordon - N1MGO

On 9/10/2020 16:24 PM, Lyn Norstad wrote:
> Hi Gordon -
>
> Yes, you can find the command reference here:
>
> https://elecraft.com/pages/kat500-fully-automatic-tuner-manuals
>
> As to the KAT500 switching modes, I am not having that problem.  I suggest you go thru the Configuration making certain to memorize critical frequencies then run it in Manual mode.
>
> 73
> Lyn, W0LEN
>
>
>
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Gordon LaPoint
> Sent: Thursday, September 10, 2020 1:53 PM
> To: Elecraft Discussion List
> Subject: [Elecraft] KAT500 Remote software help
>
> I'm using the KAT500 with the remote software.  Is there any
> documentation of the command line switches for this software?
>
> I have it set to start on bootup, connecting to a specific port at the
> correct baud rate, it works, but switches the tuner from manual mode to
> auto mode.
>
> How do I prevent this?
>
> Gordon - N1MGO
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lyn at lnainc.com
>