[Elecraft] [K3] KAT3 not functioning on 6m

[Nr4c]

Tune before you run wsjt. 

The ATU I think forces the VFO into CW mode. Split in a DATA Mode is not allowed if one VFO is not in same DATA Mode. 

Sent from my iPhone
...nr4c. bill


> On Sep 10, 2020, at 12:57 PM, David Needham <aa4vt.dave at gmail.com> wrote:
> 
> Bill,
> 
> It looks like you have uncovered the same apparent firmware glitch I did. I
> have verified a few friends have the same issue. It is very repeatable on
> K3 and K3S's.
> 
> I was using split mode for WSJT-X and when I would press Tune while in Data
> Mode A to tune my KPA-1500, I get zero power output. If I take the rig out
> of Split mode, it works just fine. Put it back Split mode, still works
> fine. Turn the rig off and on again, zero power out again.
> 
> My solution was also to run WSJT-X in Fake It mode, but I really would
> prefer to be able to use Split mode. Maybe one day one of the firmware
> updates will correct that.
> 
> -- 
> Thank you!
> David Needham, AA4VT (formerly K4AJA and K8AJA)
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com