[Elecraft] [K3] KAT3 not functioning on 6m

[Richard Ferch]

The K3 allows split in data modes, but only provided both VFOs are already
in data mode. The K3 will not allow cross-mode split between Data and
CW/SSB.

If you are seeing "SPL N/A" when you try to enable split with VFO A in a
Data mode, what that tells me is that VFO B is in CW or SSB, not in Data
mode. When VFO B is not already in the same mode as VFO A, tap A>B twice to
transfer the VFO A mode into VFO B before pressing Split.

73,
Rich VE3KI


W4SC said:

The K3 only allows the "split" mode for SSB and/or CW  to be enabled, at
least from \
panel.  Trying to enable split in any other mode, the VFO B window flashes
"N/A".   \
You may have different indications / results if the split command is sent
via the \
CAT, and a mode other than CW or SSB is selected.