[Elecraft] Fwd: Re: K2 upgrade kit sequence

[Don Wilhelm]

Bryan intended this to go to the reflector.  See below:
73,
Don W3FPR
-------- Forwarded Message --------
Subject: 	Re: [Elecraft] K2 upgrade kit sequence
Date: 	Thu, 29 Oct 2020 17:41:33 +0000 (UTC)
From: 	Bryan Nehl <k0emt at dbbear.com>
To: 	Don Wilhelm <donwilh at embarqmail.com>



Don,

While the keying mod kit instructions haven't been updated, the K2 
manual has been updated for the SMD diode on a carrier board 
installation. Pg 60 of the Rev I k2 manual.

I was able to order all of the parts for the keying modification from 
Elecraft.

Here is the list of parts:

Elecraft K2 Keying Modificaton Parts LIst
Ref 	Description 	Quantity 	Part Number
C31, C46 	Capacitor, 0.01uf monolithic (103) 	2 	E530009
C45 	Capacitor, 22uf Electrlytic 	1 	E530012
R22 	Resistor, 82k, 1/4W, 5% (gray-red-orange) 	1 	E500119
R21 	Resistor, 270k, 1/4W, 5% (red-violet-yellow) 	1 	E500101
MIsc 	Hookup wire, #24, green (used for insulation only) 	4 inches 	E760008
RF-D36 	SMT1B,
pin diode supplied on pc
daughterboard 	1 	E120014



72 de Bryan, k0emt