[Elecraft] KPA1500 Using Multiple Antennas With the Tuner

[ockmrzr at gmail.com]

Jim,

I have been following the thread.  Same, same here.  K3 driving the KPA1500, using AN1 jack only to a 6 PAK that is controlled by a Bandmaster V connected to the K3 for band data.  I am going to try OPER / STBY trick when changing bands. 

73 de Bruce, N7TY
Yuma, AZ
www.qsl.net/n7ty

-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On Behalf Of Jim McCook
Sent: October 16, 2020 13:49
To: Elecraft Reflector <elecraft at mailman.qth.net>
Subject: [Elecraft] KPA1500 Using Multiple Antennas With the Tuner

Jim, Thanks for the info.  You understand the problem for sure.  Dick is being very helpful now, but I'm getting erratic data for him because switching between antennas sometimes only results in "NEED TUNE PWR" 
with OK result after a few seconds, and other times I get the fault due to initially high SWR and high power output.  I'll probably go with switching to STBY before applying RF to the new antenna.  That way the instant mismatch won't create a fault due to 1800w output!  BTW I hope your house was unaffected by the fire.  I feel badly for Bob.

Dave.... that ANT1 ANT2 arrangement will not work with my setup for other reasons.  Thanks anyhow for the suggestion.

Jim
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to ockmrzr at gmail.com