[Elecraft] K3 appears to be in AM even though mode says DATA

[Tom Azlin W7SUA]

Thanks Don.

I had changed nothing in the radio. Had been working just fine up to 
this afternoon! Not just the filter, the radio is in AM mode even though 
the mode says DATA.

Will go look at the filter set up!

Tom


On 10/6/2020 3:55 PM, Don Wilhelm wrote:
> Tom,
> 
> You likely have the 6 (or 13) kHz filter enabled for both DATA and AM 
> modes.  Use K3 Utility Filter Calibration to change it.
> 
> 73,
> Don W3FPR
> 
> On 10/6/2020 6:25 PM, Tom Azlin W7SUA wrote:
>> Hi.
>>
>> My K3 seems to switch to AM around 5 MHz even though the display says 
>> DATA. And the filter highlight on my P3 also switches to the AM width 
>> around tuned freq.
>>
>> Earlier I had tuned to 5 MHz WWV to do a sound card calibration and 
>> switched mode to AM. Now was trying to test my fldigi FMT Modem 
>> against 5 MHz WWV so switched to DATA. Still shows as if I am in AM mode.
>>