[Elecraft] P3 question

[Thaire Bryant]

Thanks to all.  I rechecked each connection and after really pushing in on the RS 232 connection to the K3s the screen popped!  What a great group, I had checked all before but apparently didn’t push hard enough on this one!

73,
Thaire. W2APF

> On Nov 23, 2020, at 18:50, Nr4c <nr4c at widomaker.com> wrote:
> 
> Make sure all connectors are firmly seated. 
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On Nov 23, 2020, at 6:05 PM, Thaire Bryant <tbry441 at myfairpoint.net> wrote:
>> 
>> I just finished rewiring and rearranging my operating position (K3s, KPA1500 and P3) along with my station computer.  On reassembling I found that all was good except for the P3, I lost the signal display and the waterfall.  I have no problem connecting to the three utilities and all show up to date firmware. The P3 shows the center frequency (VFO A) and displays PEP and SWR.  I have rechecked all connections and all appear to be correct.  Any ideas?  I can not find any help in troubleshooting areas of manual or Fred Cary book.
>> 
>> Thanks & 73
>> Thaire. W2APF
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nr4c at widomaker.com 
>