[Elecraft] WSJTX Weird shift on different bands

[Joe Subich, W4TV]

> HOWEVER, on 15M (21.074), 17M and 12M - with this setup,  I get NO 
> decodes, and on the P3, I see the passband in the CENTER of the
> display, and the signals are all to the right of the passband.
Check your data sub-mode (DATA MD) *one each band*.  The sub-mode
is stored *per band* and it would appear that yours is set to
AFSK_A (LSB centered on the dial frequency) instead of DATA_A (USB).

It is likely that the sub-mode on 15, 17, 12 is incorrect (probably
because your logging/data program set it to AFSK_A when you last
operated RTTY on those bands).

73,

    ... Joe, W4TV


On 2020-11-16 12:02 PM, n7qnm at n7qnm.net wrote:
> I'm certain I'm doing something stupid, clearly I don't understand the
> SSB/data shifting going on; but, I can't seem to figure this out.
> 
>   
> 
> I'm running a K3 with a SignaLink USB connected to the rear-panel and WJSTX,
> primarily for FT8 (although see below).     WSJTX is set for "Ham Radio
> Deluxe" rig control, VOX ptt and Data mode.
> 
>   
> 
> On 40m (Dial freq 7.074),  20m (14.074), and 10M (28.074) FT8, this works
> great.   Lots of decodes and lots of QSOs.   On my P3, the passband is to
> the "right of center" and the signals are right in the middle of the
> passband.
> 
>   
> 
> HOWEVER, on 15M (21.074), 17M and 12M - with this setup,  I get NO decodes,
> and on the P3, I see the passband in the CENTER of the display, and the
> signals are all to the right of the passband.  I manually switch the radio
> to USB (from data), then the P3 passband shifts to the right and I start
> getting decodes; but can't transmit, since the audio source for the K3
> switches from LINE to MIC.
> 
>   
> 
> Help????
> 
>   
> 
> 73 de N7QNM
> 
> Clay
> 
>