[Elecraft] improper TX data mode

[Joe Subich, W4TV]

Dick,

Check your data sub-mode (DATA MD) on *each band*.  Make sure 80, 40, 30
and 12 m are not set to AFSK_A instead of DATA_A.

The data submode is band specific and may have been set to AFSK_A by
your software if you happened to have operated RTTY.

73,

    ... Joe, W4TV


On 2020-11-13 5:51 PM, Dick Frey wrote:
> I cannot operate FT8 on 80 60 40 30 or 12m. It works fine on the other
> bands.
> Data mode (usb) is selected on all. However, on the P3, the filter window
> is displayed improperly on the bands that don't work -- it is centered on
> the display and is actually LSB because I can ALT the mode and copy FT8 but
> not send. Properly, it is on the high side of center on the bands that do
> work.
> 
> Any ideas on what I have fat-fingered?
>