[Elecraft] Problems with KRX3A

[Gareth M5KVK]

Thanks, Ben
I'm going to open her up again and do another check on the seating of the KRX3: it's quite difficult to be sure both the multi-way connectors are properly mated. I'm also going to check continuity on all the leads.

Gareth, M5KVK

On 28/05/2020, 17:38, "elecraft-bounces at mailman.qth.net on behalf of w4sc" <elecraft-bounces at mailman.qth.net on behalf of w4sc at windstream.net> wrote:

    Ref pp 43 of KRX3 Istallation and User Guide  Rev F  Dec 22 2010

    ALWAYS  Set ANT = BNC if not connected to KAT3.

    Clarification:    I believe config selection ANT=ATU may be inserting attenuation during transmit in the KRX3 signal path to provide protection.

    Make sure KSYN3 tmp connections good. I had the KRX3 “dead” issue on friends K3.

    Ben W4SC

    Sent from Mail for Windows 10

    ______________________________________________________________
    Elecraft mailing list
    Home: http://mailman.qth.net/mailman/listinfo/elecraft
    Help: http://mailman.qth.net/mmfaq.htm
    Post: mailto:Elecraft at mailman.qth.net

    This list hosted by: http://www.qsl.net
    Please help support this email list: http://www.qsl.net/donate.html
    Message delivered to gareth.m5kvk at gmail.com