[Elecraft] KX3 SPL N/A Message

[Nr4c]

Mine did. If you tell wsjt to use split it will set it. 

Sent from my iPhone
...nr4c. bill


> On May 21, 2020, at 9:00 AM, Will Hrachovina K4MI <will at k4mi.net> wrote:
> 
> In order to operate split with data modes, both VFO A and B must be in ‘Data’ mode. The quickest way to make this happen is to hit the ‘A=B’ button which would set both to the same frequency and mode. Then WSJT should work in split mode.
> 
> Not sure why WSJT doesn’t automatically do this, but it may be a difference from the K3 to the KX3.
> 
> Will Hrachovina
> K4MI
> Sent from my iPhone for Verizon
> 
>> Previous message follows:
>> KX3 + KXPA 100 + PX3 (upgraded to latest firmware)
>> 
>> 
>> 
>> Mode: DATA A
>> 
>> Band: Any
>> 
>> 
>> 
>> In WSJT-X I enabled Rig Split operation. Running FT8 mode.
>> 
>> 
>> 
>> At the beginning of every transmit I briefly see "SPL N/A"
>> 
>> Not sure why or what it means. 
>> 
>> 
>> 
>> I made QSOs, previously I used Split Operation "Non" and "Fake It" settings
>> and they work just fine.
>> 
>> 
>> 
>> Any explanation of "SPL N/A" appreciated - RTFM does not yield any answers
>> unless I missed something.
>> 
>> 
>> 
>> 73 de k1jbd
>> 
>> Bammi
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com