[Elecraft] Elecraft Digest, Vol 193, Issue 35

[rocketnj at gmail.com]

That is fine for resonant antennas but I would like to monitor between the
amp and tuner.

I know the amp has a sample out port for adaptive predistortion. I had
changed the two small (very small) resistors on the filter board to adjust
the sample out level to work with an Anan radio with no attenuation. I
believe the new amps are shipping with this mod already done.

Too bad the sample out couldn't be used on the LP700...

Dave wo2x


-----Original Message-----
From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net> On
Behalf Of Warren Merkel
Sent: Wednesday, May 20, 2020 12:47 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Elecraft Digest, Vol 193, Issue 35

I definitely wouldn't bother to modify the KPA1500 to have a monitor loop!

I bought two sensors -- one between the K3 and the KPA1500, and the other
between the amplifer output and the antenna feedline.  The
LP500/LP700 supports up to four sensors.

This allows easy swapping from exciter output to amplifier output with a
button press, and allows amplifier linearity monitoring using the LP700.

Warren, KD4Z

On 5/20/2020 11:38 AM, elecraft-request at mailman.qth.net wrote:

> 
> I am thinking about adding a Telepost LP700 to my station but I would 
> need to insert it between the amp and tuner (which are integrated 
> together in the KPA1500).
> 
> Any ideas if it is worth doing something to loop the RF out of the amp 
> to the coupler and back in again? Probably no easy way to do it.
> 
>   
> 
> Just a thought.
> 
>   
> 
> Dave wo2x

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to rocketnj at gmail.com