[Elecraft] Frequency/Rx Calibration Elecraft K2

Don Wilhelm donwilh at embarqmail.com
Sun May 17 11:10:10 EDT 2020


Al,

Your signal generator will not be of any use.
You WILL need the internal frequency counter probe - you can order the 
kit from Elecraft.

Go to my website www.w3fpr.com and open the article on K2 Dial 
Calibration.  It contains complete information.

Your audio spectrum analyzer can be useful when tuning in WWV - look for 
the transmitted tones (500 and 600 Hz) to appear at the proper audio 
frequency.

73,
Don W3FPR

On 5/17/2020 9:41 AM, W4RAM wrote:
> I am looking for assistance with the following:
> I want to calibrate the frequency reception in my Elecraft K2(01215).
> Although I have read several posts, I am still confused with the procedure.
> I don't have the frequency counter probe that the manual mentions.
> I have a Signal Generator and audio spectogram software, what can I do with
> this two to calibrate the K2?
> I am looking for guidance in the process.
> 


More information about the Elecraft mailing list