[Elecraft] Macro to change Serial from RS232 39400 to USB and back...

[Gerry Hull]

Hey folks,

This is a technical one where I'm not sure of the correct macro.

Situation:

K3s, Remote via RRC 1258, using the serial connection.
However, we want an alternate remote that is supported by N1MM on the
desktop.

Therefore, I want to be able to switch between USB and RS-232 ports for rig
control.

When on the Remote, I can just use the K3/0 menu to switch to USB, at which
time I'll
lose rig control.

Then, using Anydesk/Teamviewer/etc ... I can connect N1MM on the remote PC
and play radio over the USB port.

However, I won't have a way to set the rig back to RS-232 38400 to use
RemoteRig again...

Solution?

However, there seems to be the RS232 MN057; macro, which gets you to the
RS232 menu setting.  I'm just looking for the right sequence to go either
direction; obviously, I'll need to be connected on the right port to move
control back

And... I'll only test this when I'm local in the station! :-)

Any help appreciated.

73,

Gerry W1VE