[Elecraft] CM500 headset on K3S and KX3?

[Dick Dievendorff]

This isn’t an endorsement from my company, but I’ve been real happy with my Inrad W1. It has a real 1/4 inch phone plug, robust and coiled cord longer than normal, it’s quite comfortable.  I have not used the microphone much, but it’s been fine.  Foam covered mike, easy to move out of the way.
Replacement ear pads, should I ever need them, are $10.

I find in longer contests that I like to change headsets to move the pressure points. So I have acquired several over the years. My old Sony MD-V is also a favorite for CW contests.

Dick, K6KR


> On May 9, 2020, at 14:27, stephen shearer <sm.shearer.01 at gmail.com> wrote:
> 
> I purchased a Heil Prpset about the same time 2010+/- and they were leaving "black bits" around too.  Yes, the Heil is more expensive.  I was able to purchase new foam from the DC Store.  I searched HRO and they had stock, if you knew the part number.  I now have a new Headset...  I DO like the HC4 element and the cotton ear pads...
> 73, steve WB3LGC
> 
>> On 5/6/20 12:53 PM, Walter Underwood wrote:
>> My CM500’s earpads are flaking pretty badly, leaving little back bits around the home office/shack. They still work fine.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dick at elecraft.com