[Elecraft] height of k4 with legs extended

[Richard Donner]

Hi  Dick
   Thanks I will probably move my monitor  to slightly above 7 inches.
At present it is a little bit too high over my k3.    The monitor bottom is
9.5 inches up from the table that the k3 sits upon.
I do not like looking up.
I am going to ponder this a bit
73   Richard


On Thu, May 7, 2020 at 12:13 PM Dick Dievendorff <dick at elecraft.com> wrote:

> I just measured my KPA1500 as 6-3/4".  I used a tape measure, I could be
> off
> a little.
>
> I don't have a K4 here, but I've seen one side by side with a KPA1500. The
> intent is that they're the same sized box and that they line up with bottom
> bail extended.
>
> I'd allow a little extra room for airflow (and my measurement accuracy).  I
> believe air is intended to come in from the top and out the back. I don't
> know the K4 specification for airflow clearance.
>
> KPA1500 air comes out the top and bottom edge, and an inch of free airflow
> space is required above the amp. I wouldn't expect the K4 to require any
> more than that inch of airflow space.
>
> 73 de Dick, K6KR
>
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net <elecraft-bounces at mailman.qth.net>
> On
> Behalf Of Richard Donner
> Sent: Thursday, May 7, 2020 12:00
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] height of k4 with legs extended
>
> Hi
> Anyone know the height of the k4 with front legs extended.   I am going to
> mount a monitor suspended over it.
> bye Richard
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message
> delivered to dick at elecraft.com
>
>