[Elecraft] KPA 500 fault!

[Jack Brindle]

A “270V ERR” fault indicates that the TR switch bias supply is not working. This may be caused by the top cover being removed, the safety switch attached to the top cover becoming loose or an actual failure of the 270V supply. Since your main HV supply is now down close to 0V, it looks like you have power supply issues. You should call technical support on Monday to get help.

73 and good luck getting your KPA going again.
Jack, W6FB


> On May 3, 2020, at 11:32 AM, Tom Doligalski via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> My KPA500 has been working fine waited for 115 V. Just now it has been throwing a “25=70 VAC” fault!
> 
> Can anyone lead me in helping this? Fuses look good. HV read 0.1 v when in standby, which is FAR from the 70 some volts it used to read. 
> 
> Thanks!
> 
> Tom W4KX
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com