[Elecraft] KX3 Advice on removing front bezel for cleaning.

[Grant Youngman]

Check the assembly errata.  It’s corrected there.   Figure 16 is correct.

Grant NQ5T

> On Mar 25, 2020, at 9:41 PM, Mike Parkes <mspmail2 at gmail.com> wrote:
> 
> Hello team Elecraft
> I have some minor dust intrusion into the KX3 behind the bezel and wanted
> to remove it and do some light cleaning. Is there anything to be aware of
> before removing the VFO knob and the bezel?
> 
> The assembly instructions say: "*Place the bezel on the front panel and
> secure it, and the CP board inside, as shown in Figure 14"*. (But figure 14
> shows* "Preparing the Rubber Washer for Mounting on the VFO B Encoder"*...
> is this meant to say Fig 16?) Fig 16 shows the bezel in place, I guess the
> bezel is being screwed into the CP board? I don't want to start into this
> and screw something up! Thanks for any tips if you have any.
> 
> 73's to Mike AB7RU
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to ghyoungman at gmail.com