[Elecraft] K3 doesn't work in AFSK-A mode but DATA-A does work. What's broken?

Jim Rhodes jimk0xu at gmail.com
Sat Mar 21 10:23:06 EDT 2020


OK, I set things back up with AFSK for RTTY instead of FSK. My results were
the same as Joe's. If I set data mode to DATA A things work as expected
whether using VOX or my usual interface for PTT. However when I switch data
mode to AFSK and VOX on and hit the TX button nothing happens, if I plug in
the FSK interface just for PTT the K3 goes into transmit but there is no
output and no tones in the monitor.  My only conclusion is that there is
some logic in the K3 or the new USB interface that is not routing the audio
properly in AFSK mode. This is apparently not the case with the K3S.  So
Joe there is your answer. It is not your setup it is the radio. Maybe when
the K4 is all rolled out they can take a look at the firmware and come up
with a solution.  My current FSK interface is 2 transistors and 2 resistors
in each of 2 db9s connected in parallel to the db15hd pins for PTT & FSK.
This allows for SO2V operation with minimal fuss. I have never owned a
commercial interface, so have no experience with them.

On Sat, Mar 21, 2020 at 6:26 AM n9ok <n9ok at arrl.net> wrote:

> Thanks to all who've provided suggestions.
>
> I've given up on making ASFK-A work with RTTY and am going back to FSK.
> It's
> a more complex setup, but it works. The engineer part of me is pretty
> irritated about this. I don't like giving up on problems. However, I think
> I've done everything I can on this end and I have better things to do than
> to stress about this.
>
> 73 Joe N9OK
>
>
>
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jimk0xu at gmail.com
>


-- 
Jim K0XU
jim at rhodesend.net


More information about the Elecraft mailing list