[Elecraft] KXFL3 Adjustments

[Don Wilhelm]

Mike,

I assume you are using the internal oscillator.  Do you have a 2 turn 
loop on that 'piece of small coax'?  If not, you will not have a 
sufficiently strong signal.

Set the menu values back to the defaults and try again.

73,
Don W3FPR

On 3/8/2020 10:49 PM, Mike Short wrote:
> I am doing the alignment following the install, and I do not hear any
> difference regardless of phase/gain, or preamp setting. There is also
> no difference in S meter display either. I am using a piece of small
> coax as the pickup antenna. Any suggestions?
>