[Elecraft] High Current only on 20 Meters

[Leroy Buller]

Bob,

Yes I think you are right but I think the amps Hp and Lp are ok because it
just happens on 20 mtrs.  I think there is something bad in the LPF or
ATU.  I betting on the ATU.  But not for sure.  Emailed support
Lee

On Wed, Mar 4, 2020, 2:11 PM Bob McGraw K4TAX <rmcgraw at blomand.net> wrote:

> I would run a TX gain calibration using the K3 Utility and a 50 ohm dummy
> load.   Then with an external power meter and dummy load, observe the power
> output on each band.   Be sure the ATU is bypassed for this measurement.
>  This would isolate the issue to the PA, ATU or low pass filter which is
> band dependent.
>
> Bob, K4TAX
>
>
> Sent from my iPhone
>
> > On Mar 4, 2020, at 12:46 PM, Leroy Buller <lee.buller at gmail.com> wrote:
> >
> > I have a K3 that seems to have a problem.  I am getting HI CURRENT
> warning
> > only on 20 meters.  The antenna is matched.  80, 40 and 15 do not have
> the
> > issue.  The current meter on the power supply does show quite a bit of
> > current (20+ amps) on 20 meters but when I reduce power it stops giving
> me
> > the issue on 20 meters.  When I reduce power on 20 meters, the high
> current
> > goes away around 65 watts.
> >
> > Anyone have an idea what is going on?  I do appreciated the help
> >
> > Lee - K0WA
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to rmcgraw at blomand.net
> >
>
>
>