[Elecraft] Unwanted audio

[Martin]

Nice try,
but no, 2 TONE is OFF . I should've said that.

As a workaround I reduced Mic Gain a little, switched on TX Gate and set 
it to a level the tone wouldn't trigger TX Gate. Now it is not audible 
anymore when i don't speak, but comes on again as i trigger TX Gate with 
my voice.
It is not very loud, but the otherwise beautiful audio is 'unaesthetic'.

Thank you.

Am 04.03.20 um 02:43 schrieb Bob McGraw K4TAX:
> Check the CONFIG menu for the 2 TONE.  Make sure it is OFF.
> 
> 73
> 
> Bob, K4TAX
> 
> On 3/3/2020 2:31 PM, Martin wrote:
>> Elecrafters,
>> my K3 shows a strange Problem. On USB it transmits a tone at about 
>> 2khz above (respectively on LSB about 2khz below) carrierpoint. This 
>> happens even with no mic attached. The level of the tone follows the 
>> setting of the 2.4khz level of TXEQ. It also follows Mic Gain level.
>> Anyone know what to do?
>> Setup: Dynamic Mic on Frontpanel (or removed, doesn't matter), tap 
>> XMIT, listen on sdr-console.
>>
> 
> 

-- 

Ohne CW ist es nur CB..

73, Martin DM4iM