[Elecraft] K2 after kat2 install Q7 & 8 check

[Russ Edelen]

When I check, both show no resistance reading. Shorted probes read -1`or 
zero. I am reading from both the holding bolt and a 2D block to the 
collector.

The kat2 instructions say to look for greater the 100 ohms and the k2 
manual says to check for a short for proper installation. Infinite 
resistance meets these criteria but I'm not sure that's a proper 
interpretation.

k2 is second hand No. 01112
firmware 2.04

Thanks for any clarification.
Russ
KG7VQ