[Elecraft] Low tone audio Tx

[Jim Brown]

On 6/18/2020 8:30 PM, oz6abm at qsl.net wrote:
> How do I get my K3 Tx audio to have more “punch”.

Set TXEQ as follows: Three lowest bands max cut (-18 dB), fourth band -6 
dB, two highest bands +3 dB. Turn COMP all the way down, then set Mic 
Gain per the manual. NOW, turn up COMP, set the display meter to read 
Comp, and while to talk like you would on the air, increase COMP until 
you see about 10 dB of COMP on the meter on voice peaks.

Now get some signal reports from "good" listeners. Tell them to listen 
with their widest IF filter setting. Tell them you DON'T want "warmth" 
or "fullness," you want a signal that will cut through QRM an noise, but 
still sound pleasant. Depending on your mic and your voice, you may want 
to use more or less cut of the 4th band, and a little more boost of the 
top two. Don't go higher than 6 dB.

73, Jim K9YC