[Elecraft] [KX3] Oppopsite Sideband Null question - Redux

[len at ka7ftp.com]

By "up to date" I assume you mean firmware?


-----Original Message-----
From: elecraft-bounces at mailman.qth.net [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mark Forsyth
Sent: Friday, June 12, 2020 10:18 PM
To: Grant Youngman <ghyoungman at gmail.com>
Cc: Elecraft Refl <Elecraft at mailman.qth.net>
Subject: Re: [Elecraft] [KX3] Oppopsite Sideband Null question - Redux

Hi,
Elecraft have a handy little utility called RxSbNull.exe which does the whole process. All you need is an up to date KX3, an up to date XG3, a Windows computer and the utility. It works like a charm. Turn the radio volume down before you start it though otherwise it’ll annoy the hell out of you. 

Cheers
Mark Forsyth
http://jandmf.com
VK3KW 

> On 12 Jun 2020, at 11:36 pm, Grant Youngman <ghyoungman at gmail.com> wrote:
> 
> Elecraft Tech Support seems (understandably) a bit slow to respond at this point.   This is a repeat of a question I asked a few days ago.  Maybe someone else will see it and have some insight (?).
> 
> I have redone the opposite sideband null procedure in my KX3 (#8342) with KXFL3 filter board, using both the 2013 per-band null procedure, and the 2015 KXFL3 installation/calibration instructions.  The procedures are essentially the same, with a minor difference in RIT setting, and the fact that the KXFL3 installation manual calls this out only on 20M rather than on each band individually.
> 
> With my XG3 as a signal source,  I get an excellent opposite sideband null using either FL1 or FL2 bandwidth settings on all bands.  With narrow bandwidth and FL3 switched in, the null is very broad and shallow, and the opposite sideband is reduced only on the order of 10dB (+/-) rather than the very deep nulls (60+ dB) obtainable with FL1/FL2.  As a result, the opposite sideband remains clearly audible when tuning across a signal — say CW at 500 Hz bandwidth, etc.
> 
> If anyone else out there has done either of these procedures, did you get as deep a null with FL3 as with FL1/FL2?  I’m trying to determine if this is normal, or if there's an issue in the radio, possibly with my KXFL3 board.
> 
> Thanks … Grant NQ5T
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net Please help support this email 
> list: http://www.qsl.net/donate.html Message delivered to 
> vk3zmf at outlook.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to len at ka7ftp.com