[Elecraft] stripping insulation from enamel wires

[George Winship, NC5G]

<The instruction say:
-dip in a solder pot which I don't have>

I have used the solder blob method with success. However, when I was
building my K2 about 19 years ago, I used an old bullet shell casing for a
solder pot. Secured it with vice grip pliers to hold it verticle, laid the
soldering iron to side of the casing to melt the solder inside, then dipped
the wire into the casing. It worked well.

73, George NC5G



--
Sent from: http://elecraft.365791.n2.nabble.com/