[Elecraft] Two instances of WSJT on K3s with SubRX?

[Joe Subich, W4TV]

Since WSJTX does not understand the concept of a second receiver there
is no way to provide CAT control for the Sub RX or transmit on VFO B
as if it were a separate rig.

However, you can start a second instance of WSJTX to receive on the
Sub RX - start WSJTX with the --rig command line argument (see the
WSJTX Users Manual sec. 16.5).  You will probably also want to
specify a special configuration for the Sub RX that sets the RX
Soundcard to "USB Audio CODEC" <RIGHT> so it is listening to the
correct receiver.  Specifying a start-up configuration is done with
the --config<configuration-name> command line switch (WSJTX Users Guide
sec 10.1.3)

As the developers of WSJTX are fond of saying - "Study the On-Line
Users Guide!"

73,

    ... Joe, W4TV


On 2020-06-08 4:23 PM, Jim Miller wrote:
> Has anyone run two instances of WSJT on a single K3s with the SubRX so as
> to be able to monitor both 50.323 and 50.313?
> 
> Of course I'll only be able to transmit on the instance that has the Main
> RX but it would be handy to be able to see both.
> 
> Thanks
> 
> Jim ab3cv