[Elecraft] Using the KPA1500 with an ICOM IC-7300

[John Simmons]

Tom,

You might shoot an email to WX0V (his email is on QRZ). Since he 'wrote 
the book' he might be able to help you the best. I know his Dad, W0ELM 
quite well and he is a great guy so Scott must be too. BTW, I suspect 
there may be a 7300 menu setting causing the problem.

73,
-de John NI0K

Tom Whiteside wrote on 7/21/2020 5:16 PM:
> My early vintage K3 headed back to Elecraft for repairs this week and I'm
> trying to get my ICOM IC-7300 to fully interface with the KPA1500.   I have
> followed the instructions Elecraft includes in the manual plus a great video
> from WX0V - I can key the amp just fine but the amplifier is not tracking
> band changes by the IC-7300.    I have the stereo cable going between the
> KPA-1500 XCVR Serial and the IC-7300 CI-V Remote control jack and the
> KPA1500 key-in RCA plug connected to the IC-7300 send control jack.
>
>   
>
> On the KPA1500, I have the Serial Speed host set to 19200bps and the Serial
> Speed XCVR also set to 19200.   Not sure what the Serial Speed Host is for -
> it is not mentioned in the instructions for the IC-7300.  Radio Type is
> ICOM.  On the IC-7300, the CI-V USB baud rate is also set for 19200, CI-V
> Transceive is on and the CI-V Output is on.
>
>   
>
> I have tried other baud rates.   Anyone have any ideas?  Thanks!
>
>   
>
> Tom N5TW
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jasimmons at pinewooddata.com