[Elecraft] k2 cap

[Don Wilhelm]

Carlos,

Yes, that is an unfortunate effect of the difficulty in obtaining 
thru-hole capacitors.  That particular one cannot be bent over because 
it will interfere with the PA transistor mounting.

If you also ordered the KSB2 option, there is an extra 0.01uF (10nF) 
capacitor in that kit.  It has a narrow lead spacing, but can be used to 
solve this problem.  If no KSB2, then do you have a capacitor that you 
can use instead of the one supplied.

73,
Don W3FPR

On 7/1/2020 5:19 PM, carlos.p wrote:
> hi, c 135 10nf cap fitted on the bottom side of the rf board,
> between the 2d fastener and transistor
> seems sticking out to high, i wonder if someone experienced this,
> not soldered in yet, i wait for some possible comments on that,
> regards carlos on6cn
>