[Elecraft] KX3 Utility Terminal window for CW

[David Haines]

Fred says "Optionally, you can use the KX3 Utility to monitor an 
extended display of characters sent from the KX3's keyer."  I assume 
"keyer" could refer to the paddle connected to the KX3.

I can type characters into the Utility Terminal lower window and 
Transmit the CW.  The characters sent are displayed in the top window.

david

KC1DNY

On 12/31/2019 7:48 PM, Ingo Meyer, DK3RED wrote:
> Hello David,
>
>> I'm enjoying and getting a lot out of our CW discussion.  I've tried 
>> to use the KX3 uUtility for practice sending CW.
>>
>> p. 60 of Fred Cady's big, excellent Elecraft KX-Line book says I 
>> shouldbe able to use the Terminal window of the Utility to display 
>> the text of the CW I'm sending, but I've never been able to get it to 
>> work.
>>
>> Any ideas? 
>
> I use the "Terminal Window" of "Elecraft KX3 Utility" for typing CW 
> via keyboard.And the characters sent are displayed.
>
> But I can't decode characters given with the key. Only via keyboard - 
> butthat was not your intention. Did Fred Cady write if they were the 
> characters entered with a key or with a keyboard?
>
> 73/72 de Ingo, DK3RED - Don't forget: the fun is the power!
> www.qrp4fun.de - dk3red at qrp4fun.de
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dhaines at bates.edu