[Elecraft] KTCX03-1 txco installation

[Don Sayler]

I got a few replies off-list, and the module is now in and working.

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Sayler
Sent: Thursday, January 2, 2020 11:19 AM
To: Elecraft Reflector
Subject: [Elecraft] KTCX03-1 txco installation

Hi.

 

I'm installing the 1ppm txco in my K3S.

 

I'm not sure I understand this part of the instructions:
"Place the rectangular insulator over the TCXO leads so it covers the bottom
of the oscillator module."

 

Does this mean that the black foam insulator goes between the TCXO and the
KREF3 board? Does the insulator go such that it is 'parallel' to the TCXO,
or at a right angle so the insulator sticks out a little on the sides? Do
the TCXO leads poke through the insulator?

 

I read the instructions before I ordered the part, and I thought that it
would become clear once I had the unit in my hands.

 

Thanks.

 

Don W7OXR

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to dons at ieee.org