[Elecraft] P3 Goodness and questions

[Jim Finan]

Jerry,

As to your last question, there is a Nifty Manual available. Most Ham stores have them or you can go to niftyaccessories.com. 

73,

Jim

Jim Finan 
AB4AC 



Sent from my BlackBerry - the most secure mobile device


  Original Message  


From: AE4PB at carolinaheli.com
Sent: February 20, 2020 10:01 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] P3 Goodness and questions


I recently obtained a P3 and I'm and exceedingly happy! Now that I own it I
feel bad that I wasted a few years trying other solutions that introduced
noise and undue complexity into my station.

Just a few notes and questions because the manual is helpful but I don't
fully understand what I'm reading yet.



1. When using QSY the P3 unit often slides. How do most of you prevent
the unit from sliding?
2. The signal/noise floor jumps a lot and I'm not sure if that's due to
local interference or something in my setup. Based on reading I likely need
to noise troubleshoot/filter my station. I don't see an AGC setting for the
P3. Any suggestions?
3. What serial number requires the mod? My serial is 3251
4. I need a serial port screw stud - can I buy that from Elecraft when
I purchase a cable + vga card?
5. Is there a quick setup cheat-sheet anyone has for the P3?



Thanks in advance





Jerry Moore

AE4PB



______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to jimfinan at att.net