[Elecraft] TCP Port for KPA500 and KAT500

[Jack Brindle]

I suspect the addresses in the remote software are fixed, or at least that is their default. With that in mind, if you want to use the remote software, then you probably should set up the ethernet serial adapter to use those specific ports. I’m not really familiar with how the remote software is set up, but I am sure we can ask.

Hope this helps…

73!
Jack, W6FB


> On Feb 17, 2020, at 12:47 PM, VO1HPFrank <invl160 at gmail.com> wrote:
> 
> Jack
> 
> The interface is a StarTech NETRS2322P two port  Ethernet to Serial Port
> server which will eventually go at my remote to replace the PC there that
> currently runs the Host software for the KPA and KAT.  
> 
> TCP Port forwarding must be done in both routers to open the full duplex
> path between the Control PC and the remote serial server.
> 
> What I am asking is:  should I use the TCP Port numbers that Elecraft uses
> in their remote control software.?
> 
> VO1HP
> 
> 
> 
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jackbrindle at me.com