[Elecraft] 10 MHz reference osc. suggestion?

[Wes]

I have a Bodnar dual output GPSDO although I don't use it on my K3S.  Be advised 
that the software is very clunky and while you can get two different frequencies 
out, there are limitations on what they can be.

Frankly, I don't know why you would want something like this for the K3(S).  The 
high stability TCXO is fine if you leave the radio powered continuously as I do, 
otherwise, it's quite good after about a 20 minute warmup.  Use your counter to 
measure the TCXO directly and adjust the ref cal parameter manually.

Wes  N7WS


On 2/5/2020 12:48 PM, Dave Van Wallaghen wrote:
> Hi Gary,
>
> Here is the one I use: 
> http://www.leobodnar.com/shop/index.php?main_page=product_info&cPath=107&products_id=234
>
> It feeds my K3 and I also use the other port to calibrate the oscillator for 
> the main MCU on all the K2's I service.
>
> 73,
> Dave, W8FGU
>
>
> On 2/5/2020 2:43:46 PM, "Gary Peterson" <kzerocx at gmail.com> wrote:
>
>> Does anyone have any recommendations for a particular 10 MHz GPS disciplined 
>> oscillator that would work well as an external reference for a K3S?  I might 
>> also use a GPSDO as an external time base for my frequency counter.  Either 
>> recommendations or products one should avoid would be most appreciated.  Feel 
>> free to reply off list.
>>
>> Thanks in advance.
>>
>> Gary, K0CX
>> kzerocx at gmail.com