[Elecraft] HDSDR Mirrored spectrum

[vk4tux]

I had similar issue. i used a 3.5mm to 2.5mm audio cable (each end three
segment), from a Yaesu SCU-39 cable kit I was not using which looked perfect
for the job. 

However it turned out the centre segment was not wired, with same results as
above. Initially I thought my line-in was possibly not stereo on rear of my
Dell PC as it is a combo pink/blue mic/line in jack.

Found a stereo 3.5mm cable and luckily a 2.5/2.5mm adaptor for one end.
Looking much better, the display better than any of several others I have
tried incl non free.

I have found the Omni-rig cat control a little buggy sometimes, losing mode
control, and freq readout offset.
Re; setup and restart seems to get it back good.

Early days, and I think i just need more practice. I am using a realtek
sound card at the moment set 192KHz, and have ordered an ASUS Xonar U7 and
an stereo isolation lit with audio lines.

I would like a PX3 , however not at current pricing, and looking at a used
unit if some one is selling.

Adrian ... vk4tux



--
Sent from: http://elecraft.365791.n2.nabble.com/