[Elecraft] KPA500 P command not working from RPI and node red, any ideas?

[Michael Walker]

To add to my previous email, if you check with the Hams on the Node Red
Amateur group in groups.io, someone will have a KPA500 flow that already
works.

nodered-hamradio at groups.io

Mike va3mw


On Sun, Dec 20, 2020 at 10:24 PM Michael Walker <va3mw at portcredit.net>
wrote:

> Hi Dave
>
> What is the display saying when you’re trying to power it up?. I had
> NodeRed code running for it just fine never had an issue with it.
>
> I found at times I managed to get it into the binary upload mode which
> would mess it up.
>
> Mike VA3MW
>
> > On Dec 20, 2020, at 9:45 PM, davedkv <dkvernier at gmail.com> wrote:
> >
> > I've been trying all day to get the KPA500 to "wake up" with a P
> command sent
> > from a raspberry PI zero W running node red without success. Every other
> > command works perfectly.  If I hook up a laptop to the KPA500 it wakes up
> > every time using the KPA utility of course, anyone know what the
> difference
> > is?
> >
> >
> >
> > --
> > Sent from: http://elecraft.365791.n2.nabble.com/
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to va3mw at portcredit.net
>