[Elecraft] Interfacing K2 to KPA1500?

[Ken K6MR]

Use the Kenwood diagram in the KPA manual.   Use the pinout in the K2 manual for the serial port and wire accordingly.  3 wires (TXD, RXD, GND) is all you need from the K2.  Then select SERIAL as the radio type in the KPA.  You may also need RADIO POLL to be turned on.

Ken K6MR

From: eric norris via Elecraft<mailto:elecraft at mailman.qth.net>
Sent: Saturday, December 12, 2020 05:07
To: Elecraft Reflector<mailto:elecraft at mailman.qth.net>
Subject: [Elecraft] Interfacing K2 to KPA1500?

The KPA1500 Manual mentions using a K2 with serial interface for band data, but does not show how to wire it (that I can find).  I can't find it in the nabble archive either.  Does anyone know how to do this?
Thanks and

73, Eric WD6DBM


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to k6mr at outlook.com