[Elecraft] K3, KAT500, KAP500
Rick Bates, NK7I
rick.nk7i at gmail.com
Fri Dec 11 19:05:50 EST 2020
You can put (either) the KPA or the K3 on the KAT500, it can take the
weight. When I used that combo, the amp sat on the tuner, no issues.
However, it's in your better interest to allow nothing atop the K3 AND
the KPA to optimize cooling.
If you MUST stack them, shim (along the side edges) them to allow for 3+
inches of clearance to allow for heat dissipation (venting for the
fans). Again, that's not the best situation and should be avoided. (K3
on the bottom for easy control access, SHIM, KAT, KPA)
As said; you WILL have a mess of cables to address as well, RF, ACC,
serial lines, power... confining that to a small space rarely goes well
(pull on one, five more follow).
I'd suggest serious thought to come up with a better arrangement. If
you use computer control and logging, the KPA/KAT combination don't have
to be visible (just allow for cooling), and within no more than 6' of
ACC cable away from the K3... The computer can change modes, trigger
tuning etc. via the utility apps (saves a long reach too).
GL es 73,
Rick NK7I
On 12/11/2020 2:07 PM, Jim Rhodes wrote:
> That is how I would do it. KPA55 needs the most cooling. You will end up
> with a maze of wires and cables behind the stack though.
>
> On Fri, Dec 11, 2020, 13:18 Harlan Sherriff via Elecraft <
> elecraft at mailman.qth.net> wrote:
>
>> Rearranging the shack. This may have been answered before but I can’t find
>> it. Is it okay to stack the three units bottom to top:
>> KPA
>> KAT
>> K3
>>
>> 73’
>> Harlan
>> K4HES
>>
>>
>> Sent from my iPhone
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to jimk0xu at gmail.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rick.nk7i at gmail.com
More information about the Elecraft
mailing list