[Elecraft] KX3 ACC2 GPIO

[Chris Cox, N0UK]

And why does my Mac ALWAYS rewrite TRANSVERTER as TRANSPORTER?!

Chris Cox, N0UK
chrisc at chris.org



> On Aug 31, 2020, at 12:50 PM, Chris Cox, N0UK <chrisc at chris.org> wrote:
> 
> I wish to interface my KX3 to my portable 10GHz transporter system.  I have the transporter’s PTT sequencer configured to output a +ve TX Inhibit signal which I have been using to prevent my current I/F rig from transmitting until all relays have changed over to transmit.  The current rig is a Yaesu FT-817. 
> 
> I want to be able to simply switchover the PTT/TXInh cable between the two rigs, so that I can continue using the ‘817 as a backup in the event of some problem with the KX3, and so was intending to us the KX3’s ACC2 GPIO TX Inh +ve input just as I do the 817.
> 
> However, it seems that the KX3 actually has some bias applied that requires to be pulled low to enable the transmitter, rather than looking for removal of the +ve signal.  This will mean that I need more than to simple switch over the physical connectors on the umbilical cable.  Although not insurmountable, it’s not exactly ideal.
> 
> Anyone else done this or similar and, if so, what was your solution?
> 
> 73 Chris
> 
> 
> Chris Cox, N0UK
> chrisc at chris.org
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to chrisc at chris.org