[Elecraft] KX3 microphone nut size

[Rich NE1EE]

Yes ;-) I started w metric in the 70s, because it made a lot of sense. When I got my license in the 90s, I had to pick up a few Craftsman metric tape measures on one of my trips to Canada...could not find one in the US at all.

Worth noting that while you can often swap sockets and wrenches twixt US and metric...there are many sizes that have close equivalents...the same does not hold true at all for nuts and screws that I have found. Might be some that are close, but I have not stumbled across them.

On 2020-08-28 17:48:-0700, Phil Kane wrote:
>On 8/28/2020 1:49 PM, hawley, charles j jr wrote:
>
>> Metric 6 mm is close enough to thread on but wrong threads per inch?
>
>Remember that US electronics is slowly going Metric inch by inch.... :)
>
>73 de K2ASP - Phil Kane
>Elecraft K2/100   s/n 5402