[Elecraft] KX3 microphone nut size

[Gary K9GS]

Or pick up the phone and call Elecraft.  See if they will tell you the nut size and thread.If you ask very nicely they would probably drop one in an envelope and send it to you.73,Gary K9GS
-------- Original message --------From: Phil Kane <k2asp at kanafi.org> Date: 8/28/20  4:33 PM  (GMT-06:00) To: elecraft at mailman.qth.net Subject: Re: [Elecraft] KX3 microphone nut size On 8/28/2020 1:34 PM, Mooneer Salem wrote:> Tried some normal 1/4"-20 hex nuts from Lowe's too (much too thick mind> you, but should at least confirm if the diameter/TPI are correct) and no> such luck.Sometimes the easiest fix is to buy another jack and just use the nut.Then you will have a spare jack when the time comes to replace it.  Weall learn the hard way sometimes (I plead guilty to that).73 de K2ASP - Phil KaneElecraft K2/100   s/n 5402From a Clearing in the Silicon ForestBeaverton (Washington County) Oregon______________________________________________________________Elecraft mailing listHome: http://mailman.qth.net/mailman/listinfo/elecraftHelp: http://mailman.qth.net/mmfaq.htmPost: mailto:Elecraft at mailman.qth.netThis list hosted by: http://www.qsl.netPlease help support this email list: http://www.qsl.net/donate.htmlMessage delivered to k9gs at gjschwartz.com