[Elecraft] KX3 radio settings for WSJT-X

[David Haines]

I've had good luck setting up my KX3 for FT-8., but it took awhile. I 
used several good sources which I'm sure other will point you to. But 
here's my current issue:

I'm regularly getting FT-8 QSOs on 40m, 20m, and 10 m with no problems.  
The other night I decided to try 17m.  My Windoze computer replied "USB 
device not recognized."  HUH?

I been using the KX3USB and a cheap sound card in a very simple set up.

Any ideas why the PC reacts this way to 17m?   I seem to be transmitting 
and receiving fine on 17m.  Does it matter?

david
KC1DNY
KX3 #08651


On 8/26/2020 3:49 PM, Hunsdon Cary III wrote:
> I am finally getting around to setting my KX3 Up for FT-8 and have watched several YouTube videos on setting up the KX3 and read Don Wilhelm’s excellent paper on setting up Elecraft radios for digital modes (Tnx, Don).
>
> My hang up is the radio settings tab in WSJT-X:  baud rate, data bits, stop bits, PTT,  etc. Any help would be appreciated!
> Tnx & 73,
> Cary, K4TM
> H3cary at GMail dot Com
>
> Sent from Clovelly Cottage II, home of amateur radio station K4TM and the most creative Sue Cary, in the foothills of the beautiful Blue Ridge mountains of Virginia.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dhaines at bates.edu