[Elecraft] ERR TXG No Power Output

[Jim McCook]

Problem solved (so far)!  I removed all cables from the K3, opened the 
top and re-seated all the TMP connectors. When removing the cables I 
noticed the screws holding the RS232 connector were  loose and the 
connector was very slightly unseated on the left side.  After putting 
everything back together the K3 was transmitting normally again.  After 
several on/off cycles during the day it seems OK. Thanks for all the 
suggestions.

It was good to hear Eric say all the Elecraft employees are safe!  
Hopefully their homes are, too.

Jim W6YA