[Elecraft] KX3 WSJTX Split

[Bob McGraw K4TAX]

In the F2 Setup Menu for WSJT-X change the SPLIT Function to NONE.   
Then set the Radio for SPLIT mode.  That way you can manually adjust VFO 
A for RX and then set VFO B for the TX frequency.    Just keep the audio 
tone above 1200 Hz for TX.

   Resolves the problem

73

Bob, K4TAX


On 4/10/2020 4:43 PM, vk4tux wrote:
> I recieved this email from Japan ;
>
> "I decode you FT8 on 1840kHz that I send the JPG file to you.
> JAs are working split RX 1840kHz and TX 1908kHz.
> Please CQ JA on 1840kHz and RX 1908kHz if possible.
>
> The 160m frequency in Japan,
>    1810-1825kHz and 1907.5-1912.5kHz
>
> DATE   Sunrise (GMT) in JA3
> Apr 07:  20:34Z
>       
> We hope to see you on 160m soon.
> TKS 73
> Mas JA3FYC"
>
> I tried this, however on enable TX  the VFO A and B become the same
> frequency on TX from wsjtx.
> I have cat ptt and cat control enabled, with rig split set.
>
> If I use the mic to key etc, the split remains, however something about wstx
> causes the VFO's to match on TX losing the split        ?
>
> vk4tux
>
>
>
>
> --
> Sent from: http://elecraft.365791.n2.nabble.com/
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>