[Elecraft] setting KPA 100 page 48 problem

[Don Wilhelm]

Christophe,

I forgot to mention,
Before attempting to adjust the C1 null, first pre-set R26 and R27 to 
43k ohms.  Measure R26 from U5 pin 5 to ground and R27 at U5 pin 3 to 
ground.

Then go through the nulling process followed by the power setting 
process that I outlined in my prior email.

73,
Don W3FPR

On 4/9/2020 3:25 PM, Christophe aufacf wrote:
> Good morning all ,
> 
> Zero adjustment of SWR bridge (C1) page 48
> 
> as you see on the video , I set the K2 to 5Watts
> 
> https://we.tl/t-MOz5AX1v3l
> 
> I managed to adjust the SWR the K2 announces my power at 0.1 Watts !!
> 
> the consumption goes from 0.32 Amps in Rx, in Tune mode 0.5 amps
> 
> I should have 5 Watts
> 
> Thank you for your help
> 
> # K2 7369 - kpa 100 in progress